Notice that the points rotate around the Center point. By moving the Center point you can control the behavior of some tools, including Move, Rotate and Scale.

Reshape the V step slightly, as shown in (Figure 14), still in Tag mode and using the Move tool. Remember to turn the Y and Z axis buttons back on.

Click images for larger view

Tag all the points on this V step and turn off the Y and Z axis buttons again. This time press Control>Scale to activate the scale tool. Scale the V step on the X axis until it resembles (Figure 15).
Tag all the CVs on the final unmodified V step, and use the Center tool to move the center point into the position shown in (Figure 16). Next